Rotary Vaccum Evaporator

Consist of an evaporating Flask rotated by a non-sparking induction Motor in a heating water Bath

vacuum Distillation of solvent at high and low temperature is achieved quickly and efficiently by use of speed controller provided. It prevents foaming an vacuum and bumping of the liquid. Other application include vacuum drying of powders and slides. Low temperature Vacuum distillation of heat sensitive compounds. The introduction tube permits continuous feed fo the liquids into evaporating flask and also distillation under controlled atmosphere. The evaporating Flask, Pear shaped to give a larger surface area for evaporation, is clamped to a glass duct which goes through the drive unit and protrudes 120mm. Into the condenser. The condenser is crewed into the drive unit and contains a teflon inlet feed tube at its upper end. Condenser is fitted with Standard B-19 joint at top and spherical joint S-35 at the bottom for receiver flasks.

Drive unit with F. H.P. Motor, Speed Regulator, Working on 220Volts AC 50 Cycles, Single phase.

Stand: Heavy cast Iron stand with steel road. Evaporating Flask 1 Liter (approx.) With standard B-29 joint.

Glass Duct All glass connector con e with B-29, Connected Evaporating Flask and

Protrudes in the in the condenser. With Clip to hold the Evaporating Flask with glass duct.

Condenser double coil condenser for water circulation, fitted with Vacuum connection and standard S-35, ball joint for receiving flask with condenser. Receiving flask 1 Liter capacity with standard S-35 Ball Joint.

Ball Joint Clamp: – To hold the receiving flask with condenser.

High Vacuum Cock: Two way stop for the feeding tube and vacuum release. Feed tube

Model Available:

UTS: 1.53     Capacity 1 Liter
UTS: 1.53A   Capacity 2 Liters

Optional:

• Water Bath Termostate Controlled or Digital Controlled.
• As per requirement. Lifting Jack (Manual)
• Vacuum Grease

Application: For research Educational Institute Bio-Tech. & Pharmaceutical lab.